SCIENCE
New solvents can degum hemp and other bast fibres in the lab, but their full cost is unmeasured
Scientists in China compared studies of a newer way to strip the natural gum from hemp, flax and ramie fibre. The results look promising in the lab, and the industrial case is still open.
Drafted with AI, edited by Hemp'in
Hemp'in
14 November 2026 · 3 min read

The research
Deep Eutectic Solvents for Bast Fibre Degumming: A Cross-Crop Review of Systems and Mechanisms was published on 29 October 2026 in the journal Molecules. The authors are Yuan Liu, Liu Chunjie, Haohan Zhao, Jikang Chen, Siqi Huang and Liangliang Liu, all of the Institute of Bast Fiber Crops at the Chinese Academy of Agricultural Sciences in Changsha, China. The paper is peer-reviewed and open access.
This is a review: the team did not run new experiments. They gathered and compared what earlier studies found.
What they did
Hemp, flax and their cousins grow their best textile fibre in the outer stem, the bast. Those fibres are glued together by "gum", a mix of substances such as pectin and hemicellulose. Before the fibre can be spun into fine yarn, most of that gum has to come off. That step is called degumming, and it is usually done in chemical baths.
One alternative being studied is a family of liquids called deep eutectic solvents. They are made by mixing two ordinary compounds that, together, melt into a liquid at a much lower temperature than either would alone.
The review puts degumming with these solvents on a common footing across five bast crops: ramie, hemp, kenaf, flax and Apocynum venetum (a fibre plant sometimes called Luobuma). It draws on eighteen research studies and one earlier review, choosing studies with measured results.
What they found
The field has settled on a narrow family of solvents, the authors report. Choline chloride, a widely used compound, appears in almost every recipe. Mixed with urea, it worked best on ramie and kenaf, and gave the most balanced results on hemp.
- Conditions: processes run at 100 to 175 °C, and heating with microwaves shortens the treatment time.
- Results: the gum left on the fibre fell as low as 3.15% for ramie and 9.42% for kenaf.
- Reuse: the solvents were reused for three to five cycles in the studies that tested it.
The review is just as clear about what is missing:
- Evidence at the level of chemical bonds, showing exactly how the solvent removes gum, exists only for hemp and kenaf. For the other crops, the mechanism is assumed.
- No study has reported a full mass balance of the solvent, meaning where all of it goes. So the energy and water needed to recover it, and the environmental advantage often claimed, have not been measured.
- Studies judge success by different measures, with no agreed weighting or standard method, so their "best" conditions cannot be compared directly.
The authors' conclusion is that this kind of degumming is technically verified but industrially unvalidated. Scaling up the process and recycling the solvent over long periods are the priorities before it can be used in industry.
What it means, and what it doesn't
For anyone hoping to make fine hemp textiles with a different process, this is a useful map of where the science stands. The lab results are encouraging, and one solvent pair stands out for hemp.
But the review itself says the green case is not yet proven, because no one has measured the full cost of recovering the solvent. It is also a summary of nineteen sources, and the abstract gives no hemp-specific residual gum figure. Nothing here shows the process working in a mill.
We only report research and make no promises.
Words to know
Bast fibre: the long fibre found just under the skin of stems such as hemp and flax.
Degumming: removing the natural glue that binds bast fibres together.
Deep eutectic solvent: a liquid made by mixing two compounds that melt together at a low temperature.
Mass balance: an account of where every bit of a material goes in a process.
How did this land?
Ask the desk
The conversation
Open in LIFENo one has replied yet. Start the conversation.
WRITE FOR HEMP'IN
Have a story from the hemp industry?
Join Hemp'in and publish your own articles to everyone who reads News.
MORE FROM HEMP'IN NEWS

A wall's direction mattered more than its insulation, a year in an old French building shows
Hemp'in · 16 November 2026

Hemp oil and ground hurd did not improve wet alfalfa silage, but orange powder did, a study finds
Hemp'in · 15 November 2026

Hemp hurd processor Tiger Fiber files for Chapter 11 and keeps operating
Hemp'in · 14 November 2026