Hemp'in News

SCIENCE

NC State researchers turn hemp hurds into a thin film for food packaging and mulch

A North Carolina team made a plastic-like film from the woody core of hemp. In the lab it blocked oxygen and grease and used far less energy to make.

Hemp'in

9 November 2026 · 2 min read

The research

Energy-efficient cellulose acetate nanofilms from hemp hurds for circular packaging and agricultural mulch applications, by Munmun Basak, Kazi M. Yasin Arafat, Sharmita Bera, Martin A. Hubbe, Lucian A. Lucia and Lokendra Pal, all at North Carolina State University. Published in Cellulose, February 2026. Peer-reviewed and open access (full PDF).

What they did

Hemp hurd is the woody core of the stalk, left over once the fibre is taken off. It is mostly cellulose, the same stuff that makes paper. The team wanted to know whether hurd could become a thin film that could stand in for some single-use plastics, both as food packaging and as the mulch film farmers lay over soil.

They took cellulose from hurds and treated it with acetic acid, the acid in vinegar, in a process called acetylation. Then they ground it very finely into nanofibres, threads thousands of times thinner than a hair, and cast those into films. They tested the films against oxygen, water vapour, water, oil and grease, measured their strength, and compared them with plastic mulch film in a small growing test.

What they found

  • Much less energy to make. The acid treatment cut the energy needed to grind the cellulose into nanofibres by up to 81.4%, compared with untreated cellulose.
  • A good oxygen barrier. Oxygen passed through at 11.8 to 60.1 mL per square metre per day. Keeping oxygen out is what slows food from going stale.
  • Grease-proof. The films reached the top grade (Kit 12) on a standard grease test and absorbed at most 0.75% hot oil.
  • Better against moisture. The authors report 38.63% lower water-vapour transmission, and the films absorbed only 0.84% to 6.74% water.
  • Stronger. The authors report improved tensile strength, both dry and wet.
  • Seeds grew well under it. In a preliminary, controlled test, the films held moisture well and seeds germinated and grew faster than under plastic mulch.

What it means, and what it doesn't

Hurd is often the low-value part of the hemp stalk. A use in packaging or farm films would give it more worth, and a large cut in grinding energy would make such films cheaper to produce, if it carries over to industrial machines (our inference).

But this is lab work. The films were cast in the lab, not made on a production line, and the abstract gives no cost figures. The growing test was preliminary and controlled, not a field season. The paper says the films are an alternative to fossil plastics; how fast they break down in soil or compost, and how they hold up in real packaging use, are things to watch for in later work. Acetylation also uses chemicals at scale, which a full environmental comparison would need to count.

Words to know

Hurd: the woody core of the hemp stalk. Cellulose acetate: cellulose treated with acetic acid, already used in film and spectacle frames. Barrier: how well a film stops oxygen, water or grease getting through.

How did this land?

Ask the desk

Questions go privately to the desk.

The conversation

Open in LIFE

No one has replied yet. Start the conversation.

WRITE FOR HEMP'IN

Have a story from the hemp industry?

Join Hemp'in and publish your own articles to everyone who reads News.

MORE FROM HEMP'IN NEWS